Kombinerad hållare för Hall-effekt
Two-part holder accommodating sample boards and magnetic field sensor in experiments on the Hall effect. Samples and sensors are attached to the holder by means of fastening screws.
Two-part holder accommodating sample boards and magnetic field sensor in experiments on the Hall effect. Samples and sensors are attached to the holder by means of fastening screws.
Adapter for electron tubes D for connection of the heater voltage via safety experiment leads. Includes internal protective circuitry to protect the heating filament against excess voltage. Dimensions match the two-pole connector for the tubes. The use of the protective adapter, 2-pole is recommended for a number of electron tubes of the D series. The […]
Adapter for electron diffraction tube D (U19171) for connection of the heater voltage via safety experiment leads. Includes internal protective circuitry to protect the heating filament against excess voltage. Dimensions match the three-pole connector for the tube.
Like 1000669 (U19209), but consisting of 12 film sheets, 150 mm x ?12 mm, in light-tight plastic cases for a Debye-Scherrer camera.
Highly sensitive film (38 mm x 35 mm) for beta-, gamma- and X-radiation. Single packaging in opaque plastic cases allows development and fixing in daylight (duration: approx. 6 minutes). Scope of delivery: 20 film sheets (38 mm x 35 mm) in light-tight plastic cases 1 bottle of X-ray developer 1 bottle of X-ray fixer 1 […]
These accessories for the basic equipment set (U19205) are intended for investigating the following topics: scattering, absorption; dependence on acceleration voltage, emission current and penetration power, resolving power; shielding, half-width; exposure time, non-destructive materials testing. Scope of delivery: 1 Maltese cross 1 phantom 1 pin diaphragm 1 aluminum layer, stepped 5 aluminum absorbers, 0.1/0.25/0.5/1.0/2.0 mm […]
Replacement mercury tube* for the Franck-Hertz experiment with mercury: Franck-Hertz tube with Hg filling and heating furnace (115 V /50/60 Hz); article no. 1006794 or 1023094 and Franck-Hertz tube with Hg filling and heating furnace (230 V /50/60 Hz); article no. 1006795 or 1023095 *(full compatibility to the above mentioned articles is granted) Dimensions 20.3 […]
Ersättningsrör i neon för Frank-Hertz-experiment.
For structural investigations using the rotating crystal method, suitable for the Debye-Scherrer camera (contained in 1000665). Power transmission via bevel gears. Power consumption: 3 VA
Spare Tube for Complete Fine Beam Tube System 1013843. Gas filling: Neon Gas pressure: 1.3×10-5 hPa Bulb diameter: 165 mm Orbit diameter: 20 … 120 mm Measurement mark spacing: 20 mm Dimensions 35.1 x 28.2 x 22.1 cm
These accessories for the basic equipment set (U19205) are intended for additional crystallographic experiments as well as treatments of Moseley’s law, the Debye-Scherrer method, Bragg’s reflection and material tests. Scope of delivery: 4 foils, Fe, V, Mn, Cr 2 single crystals, KCl, RbCl 5 powder samples, NaF, SiC, NH4Cl, MgO, Al 2 wire samples, Al, […]
Reservrör med kopparanod för röntgenapparaterna 1000657 (230 V; 50/60 Hz) och 1000660 (115 V; 50/60 Hz).